onelinkmore UFL to SMA M.2 NGFF IPX IPEX MHF4 to RP SMA Female (Male pin) RF Pigtail WiFi Antenna Extension Cable 0.81mm for PCI WiFi Card Wireless Router M.2 Cards Pack of 2 (19.6 inch (50 cm))

Great quality, everything just fits and it's not expensive either. It's a bit hard to plug in the M.2 card but it's good as it means the connection is tight and not easy to loose. But before you buy it, just beware 2 things before you buy cable like this. 1. the connection type on your M.2 card, the "MHF4" and ther other one (i forgot the name); 2. whether it's "RP SMA" or "SMA" (and the pin whether you need male or female. P.S. it can be female cable and male pin and vise versa) (as i almost bought the wrong one before and it won't fit)

These worked perfectly to replace a mashed m.2 wifi antenna wire on a motherboard that came smashed from the factory.

Had to replace a damage cable on a WiFi card in my pc. Found these in 2in which is exactly what I needed to fit it all in the metal casing that was housing the card. The antenna part was alittle longer than the original cord but didn’t affect anything. Overall will buy again.

Very long, works in any case. Connecters fit M.2 WiFi card perfectly.

This worked great for my Intel 8265ngw and should work with most M.2 (aka NGFF) WiFi cards. Note that there are two similar sizes of connectors, MHF4 and MHF2. This one is MHF4 which is the smaller of the two. See photo for comparison.

I have a full sized metal ATX computer case (dating back to the 90's!) and I wanted to place the antennae on the top of the case, not on the backside like most PC's do, for better reception. With the huge girth of the case, coupled with it being metal meant that it blocked the wifi radio signal. The cables that came with my wifi card were way too short but these did the trick.Only thing I had issue with was that one of the connector leads that attaches to the wifi card doesn't want to stay put. I had to pinch the female socket of the wire Ever So Gently with needle nose pliers and press it down firmly to the connector lead before it clicked into place and "stuck".

Excelent product. Works great on what I needed it for. But be advised this connector is way too small for using on ESP32-CAM.

They work well